ZXV10 H11X (V1.0)Home Gateway User’s Manual
102 Confidential and Proprietary Information of ZTE CORPORATION
Signaling
Selecting the signaling protocol used for VOIP, such as
SIP/MGCP; you can also click the Apply button to re-
register the VOIP module to SS.
VOIP Status
Displaying the registration status of each subscriber line;
When In Service is displayed, it indicates the VOIP
module has been normally registered to SS, and the user
can dial the VOIP phone number. If Out of Service is
displayed, it indicates it is not registered successfully,
when VOIP phone number cannot be dialed.
Ext. number setup
Configuring length and prefix of the internal line phone
number; Length is the internal line number length
(Cannot be changed by the user), and Prefix is the
internal line number prefix (Changeable). The default
internal line number prefix is *#, so the extension number
connected to PHONE1 is *#00 and the one to PHONE2 is
*#01.
Two-stage dialing flag
Dial twice flag
After modifying the related configuration, click the Apply button to
submit modification.
Note: Upon submission of the modification, the
menu bar on the left will change along with the call
protocol type selected by the user.
To Next Page
Loading...
