Zte ZXV10 W615 - Page 42

ZXV10 W615 User Manual
40 Confidential and Proprietary Information of ZTE CORPORATION
Figure 6 Network Configuration
2. Configure the parameters.. Refer to the following table.
Parameter Description
Network Card Select the network card 1 or the network card 2 as
mesh returning network card.
Enable Wireless Mesh Enables or disables the mesh function.
Mesh ID Set the mesh identity.
Mesh Node Type Supports two types: normal node, gateway
node.The default value is normal node.
3. Click Submit.
—END OF STEPS—