Zte ZXV10 W615 - Page 63

ZXV10 W615 User Manual
Confidential and Proprietary Information of ZTE CORPORATION 61
Parameter Description
Enable Enables or disables the function of QoS classification
configuration.
DevIn The ingress of packets. Select a LAN interface or the
configured SSID. Only one interface type can be selected
at a time.
L2Protocol Specifies the layer-2 protocol for packets. The options are
IPv4, IPv6, ARP, and PPPoE.
L3Protocol Specifies the layer-3 protocol for packets. The options are
TCP, UDP, and ICMP.
Source MAC Address Source MAC address of packets.
802.1p The flag value of VLAN packets used for setting user
priority that ranges between 0 and 7 (0 means that the
priority is not set). A greater value indicates a higher
priority.
Destination Port
MIN/MAX
Specifies the destination port number (minimum value
and maximum value) of packets. The range is 0 to 65535.
Modify
Click to modify the corresponding rule.
Delete
Click to delete the corresponding rule.
Modify
Click to modify the corresponding rule.
Delete
Click to delete the corresponding rule.
Modify
Click to modify the corresponding rule.
Delete
Click to delete the corresponding rule.
DSCP Specifies the DSCP value of packets. The value range is 0
to 63.
Modify
Click to modify the corresponding rule.
Delete
Click
to delete the corresponding rule.
Proprietary configuration for IPv4
Source IP Address
MIN/MAX
Specifies the minimum and maximum values of packet
source IP address.
Destination IP Address
MIN/MAX
Specifies the minimum and maximum values of packet
destination IP address.
TOS Specifies the service type field of data packets. The range
is 0 to 255.
IP Precedence IP priority that ranges from 0 to 7 (0 indicates priority
unavailable). A greater value indicates a higher priority.
Proprietary configuration for IPv6
Source IPv6 Address
MIN/MAX
Specifies the minimum and maximum values of packet
source IPv6 address.
Destination IPv6 Address
MIN/MAX
Specifies the minimum and maximum values of packet
destination IPv6 address.