Zte ZXV10 W615 - Software Setup Interface Overview

ZXV10 W615 User Manual
Confidential and Proprietary Information of ZTE CORPORATION 5
Item Default Value
AP mode Fit AP
AP name APxxxxxxxxxxxx, where xxxxxxxxxxxx means the
Medium Access Control (MAC) address of the device
AC discovery mode Dynamic Host Configuration Protocol (DHCP),
applicable for fit AP only.
WAN mode DHCP
Wireless mode
• Network card 1: Mixed (802.11b+802.11g)
• Network card 2: Mixed (802.11a+802.11n)
SSID SSID1 is enabled.
IntroductiontotheGUIforSoftwareSetup
After log in, the software interface is displayed as Figure 1.
Figure 1 Software Interface
1. Main menu
2. Submenu
3. Parameter
Select items on the main menu for software setup.
Select sub-items to set parameters on the left submenu.