Zundapp 281 - Page 14

Fig. 25
Fig. 26
Fig. 27
Fig. 28
Take the remaining screws from
left-hand casing, 2 in magneto
section,
M6x35
(a)
and
1
under
starter spindle, M&x 65 (b) (fig. 25).
On the right-hand side, take one
screw, M 6x 50, off the base of the
cylinder (fig. 26).
Engines 267 and 276
Fit service clamp SK-A 234 by 2stud-
bolts, M8 (SK-A 246), and I locating
bolt (SK-A 123) on the left-hand
side
above
the
magneto
spindle
(fig. 27).
For
engines
281,
make
your
own
press-off
fixture
and
secure
it
with
three
8
mm
screws
SK-A
246
to
the
left-hand
casing
above
the
magneto
spindle.
(The diameter should be 6 in. (150
mm), thickness 7 mm, bore 9 mm to
take the 8 mm bolts, (see special
tools, fig. 28.)