Zundapp 281 - Page 16

The clutch gear can only be pressed
off after taking the circlip in the
casing behind the ball bearing from
its seat with a pair of pointed
pliers.
If clutch gear and both ball bear-
ings are in perfect condition, they
need not be taken off (fig. 33).
If necessary, pull the ball bearing _
from the clutch gear with a stand-
ard bearing puller tool (fig. 34).
Casings should be warmed first for
easy withdrawal of ball bearings
and bushes. Or use the puller tool
to remove them (fig. 35).
Taking off Steel Ball Selector on
engines with manual gear change
Bend up the tab of the washer se-
curing the locknut of setscrew (a).
Slacken nut, turn setscrew until
selector fork (b) can be swung away
and selector (c) can be taken out
(fig. 36).
16