Zundapp 281 - Page 5

Table of Contents
Introductaryg Notes ang: A ware Mera, Gi EEN
1. Dismantling Engine
a) Taking off Gear Change Pedal and Fan Casing . .
b) Taking off Casing Cover, left, and Kickstarter.
Ehe, «fae: NE SC
c) Dismantling Ignition System . ..........
d) Taking off Clutch Cover, Cover for Clutch and Gear
Change Setting Controls... .........-
Taking off Pedal Gear Change Spindle and Selector
ARE ee ee Er en:
PERL EE =. EE ee
g) Taking off Chain Sprocket. .......-...-
h) Taking off Cylinder and Piston . . . .......
i) Taking off Crank Casing... . 2... eee
k) Taking off Bearings, Bushes and Clutch Gear. . . .
I) Taking off Steel Ball Selector, on engines with
manual gear hunge...
e)
Engine Assembly
a) Setting Steel Ball Selector, on engines with manual
gear. ange aula Ee
b) Measuring Axial Play of Crankshaft... .....
d Fitting Crankshaft into Right Casing... ... -
d) Measuring Axial Play of Selector Shaft... . . .
e) Measuring Selector Gears... ......-.:
f) Measuring Starter Spindle . . ... - SH
g) Assembling Engine Blok. ...........-
h) Fitting Selector Shaft to Bearing on Left Casing . .
i) Mounting Sealing Rings... . 1... erre
k) Inspecting Connecting Bed...
I) Assembling Piston and Cylinder .........
m) Mounting Chain Sprocket ..........--
n) Measuring Main Drive Shaft Position. . . . - . -
o) Mounting Chiche,
p) Setting Clutch Tongue and Clutch. ........