Zurich ZR13s - Battery Reset Procedures; Battery Reset Overview; Battery Reset OBD Service

For technical questions, please call 1-888-866-579734
About the Scan Tool
DISPLAY FUNCTIONS
3
5. M (Menu) button – When pressed, displays the Main Menu.
6. LD button – When pressed while linked to a vehicle, places the
Scan Tool in Live Data mode.
7. UP button – When in MENU mode, scrolls UP through the
menu options. When LINKED to a vehicle, scrolls UP through the
current display screen to display any additional data.
8. ENTER button - When in Menu mode, confirms the selected
option or value.
9. DOWN button - When in MENU mode, scrolls down through the
menu options.
When LINKED to a vehicle, scrolls down through the
current display screen to display any additional data.
10. GREEN LED - Indicates that all engine systems are running
normally (all Monitors on the vehicle are active and performing
their
diag
nostic testing, and no DTCs
are present).
11. YELLOW LED - Indicates there is a possible problem. A “Pending”
DTC is present and/or some of the vehicle's emission monitors have
not run their diagnostic testin
g.
12. RED LED - Indicates there is a problem in one or more of the
vehicle's systems. The red LED is also used to show that DTC(s)
are present. DTCs are shown on the Scan Tool’s LCD display. In
this case, the Malfunction Indicator (“Check Engine”) lamp
on the
vehicle's instrument panel will light steady on.
13. Display - Displays test results, Scan Tool functions and Monitor status
information. See DISPLAY FUNCTIONS, below, for details.
14. CABLE - Connects the Scan Tool to the vehicle's Data Link Connecto
r
(DLC).
DISPLAY FUNCTIONS
Figure 2. Display Functions
See Figure 2 for the locations of items 1 through 15, below.
1. I/M MONITOR STATUS field - Identifies the I/M Monitor status area.
4
3
2
5
7
6
114
10
11
12
8
9
13
15
BATTERY RESET
Additional Tests
BATTERY RESET
34
If the Scan Tool cannot reset the Oil Maintenance Light, an
“instructional” dialog displays, showing the manual procedures
for resetting the indicator light. When finished viewing the
instructions, press M to return to the Main Menu.
4. The Reset Oil Maintenance Indicator
screen displays.
 If you do not wish to proceed with the
reset process, select No, then press
ENTER
to return to the System
Menu.
 If you wish to proceed with the reset
process, select Yes, then press
ENTER
to continue.
5. When the reset process has competed,
a confirmation message displays. Press
M to return to the Main Menu.
 If the oil reset was not successful,
an advisory message displays.
 To perform the oil reset by procedure, select Yes, then press
ENTER
. An “instructional” message displays, showing the
manual procedures for resetting the indicator light.
 If you do not wish to perform the oil reset by procedure, select
No, then press ENTER
to return to the Main Menu.
BATTERY RESET
You can use the Scan Tool to view the procedures for resetting the
battery monitor system following battery replacement or perform battery
reset OBD service (for BMW, Ford and Volvo models only).
To view battery reset procedures:
1. While linked to a vehicle, press M.
 The Main Menu displays.
2. Select Battery Reset, then press ENTER
.
 The Battery Reset menu displays.
3. Select Battery Reset Procedures, then
press ENTER
.
 The Battery Reset Procedures
menu displays. The menu provides
access to General Information,
and procedures to be followed
Before Battery Disconnection,
Before Battery Connection, and
After Battery Connection.