For technical questions, please call 1-888-866-579740
About the Scan Tool
DISPLAY FUNCTIONS
3
5. M (Menu) button – When pressed, displays the Main Menu.
6. LD button – When pressed while linked to a vehicle, places the
Scan Tool in Live Data mode.
7. UP button – When in MENU mode, scrolls UP through the
menu options. When LINKED to a vehicle, scrolls UP through the
current display screen to display any additional data.
8. ENTER button - When in Menu mode, confirms the selected
option or value.
9. DOWN button - When in MENU mode, scrolls down through the
menu options.
When LINKED to a vehicle, scrolls down through the
current display screen to display any additional data.
10. GREEN LED - Indicates that all engine systems are running
normally (all Monitors on the vehicle are active and performing
their
diag
nostic testing, and no DTCs
are present).
11. YELLOW LED - Indicates there is a possible problem. A “Pending”
DTC is present and/or some of the vehicle's emission monitors have
not run their diagnostic testin
g.
12. RED LED - Indicates there is a problem in one or more of the
vehicle's systems. The red LED is also used to show that DTC(s)
are present. DTCs are shown on the Scan Tool’s LCD display. In
this case, the Malfunction Indicator (“Check Engine”) lamp
on the
vehicle's instrument panel will light steady on.
13. Display - Displays test results, Scan Tool functions and Monitor status
information. See DISPLAY FUNCTIONS, below, for details.
14. CABLE - Connects the Scan Tool to the vehicle's Data Link Connecto
r
(DLC).
DISPLAY FUNCTIONS
Figure 2. Display Functions
See Figure 2 for the locations of items 1 through 15, below.
1. I/M MONITOR STATUS field - Identifies the I/M Monitor status area.
4
3
2
5
7
6
114
10
11
12
8
9
13
15
USING DLC LOCATOR
Additional Tests
USING THE DLC LOCATOR
40
5. Select the Monitor for which you wish to view Drive Cycle
Procedures, then press ENTER
.
A “One moment please…” message displays while the Scan
Tool retrieves the requested Drive Cycle Procedure. The Drive
Cycle Procedures screen for the Monitor displays when the
procedure has been retrieved.
If a Drive Cycle Procedure for the selected Monitor is not
available, an advisory message shows. Select Back, then
press ENTER
to return to the Main Menu.
6. The Drive Cycle Procedure screen
shows the specific set of operating
procedures that ensure the vehicle is
driven in such a way that all the
required “Enabling Criteria” for the
Monitor to run and complete its
diagnostic testing are met.
7. When you are finished viewing the
Drive Cycle Procedures, press ENTER
to return to the Drive Cycle Procedures menu, or, press M to
return to the Main Menu.
USING THE DLC LOCATOR
1. Select DLC Locator in the Main Menu, then press ENTER .
The Select Vehicle Model Year screen displays.
2. Select the desired vehicle model year, then press ENTER
.
The Select Vehicle Manufacturer screen displays.
3. Select the desired vehicle manufacturer, then press ENTER
.
The Select Vehicle Model screen displays.
4. Select the desired model, then press the ENTER
button.
The DLC Location screen for the
selected vehicle displays.
The DLC Location screen shows the
selected vehicle make and model, a
description of the DLC location and
whether the DLC is “covered” or
“uncovered,” and includes a picture
of the DLC location.
5. When you have finished viewing the DLC location, press any hotkey
to exit the DLC Locator.
To Next Page
Loading...