For technical questions, please call 1-888-866-579748
About the Scan Tool
DISPLAY FUNCTIONS
3
5. M (Menu) button – When pressed, displays the Main Menu.
6. LD button – When pressed while linked to a vehicle, places the
Scan Tool in Live Data mode.
7. UP button – When in MENU mode, scrolls UP through the
menu options. When LINKED to a vehicle, scrolls UP through the
current display screen to display any additional data.
8. ENTER button - When in Menu mode, confirms the selected
option or value.
9. DOWN button - When in MENU mode, scrolls down through the
menu options.
When LINKED to a vehicle, scrolls down through the
current display screen to display any additional data.
10. GREEN LED - Indicates that all engine systems are running
normally (all Monitors on the vehicle are active and performing
their
diag
nostic testing, and no DTCs
are present).
11. YELLOW LED - Indicates there is a possible problem. A “Pending”
DTC is present and/or some of the vehicle's emission monitors have
not run their diagnostic testin
g.
12. RED LED - Indicates there is a problem in one or more of the
vehicle's systems. The red LED is also used to show that DTC(s)
are present. DTCs are shown on the Scan Tool’s LCD display. In
this case, the Malfunction Indicator (“Check Engine”) lamp
on the
vehicle's instrument panel will light steady on.
13. Display - Displays test results, Scan Tool functions and Monitor status
information. See DISPLAY FUNCTIONS, below, for details.
14. CABLE - Connects the Scan Tool to the vehicle's Data Link Connecto
r
(DLC).
DISPLAY FUNCTIONS
Figure 2. Display Functions
See Figure 2 for the locations of items 1 through 15, below.
1. I/M MONITOR STATUS field - Identifies the I/M Monitor status area.
4
3
2
5
7
6
114
10
11
12
8
9
13
15
VIEWING DATA IN MEMORY
Using Scan Tool Memory
VIEWING DATA IN MEMORY
48
When you retrieve DTCs from a vehicle, the data is saved to the Scan
Tool’s memory.
Each time you retrieve DTCs, existing data in the Scan Tool's
memory is overwritten with the new data.
VIEWING DATA IN MEMORY
When you turn the Scan Tool on while NOT connected to a vehicle, and
data is currently saved in the Scan Tool’s memory, the Scan Tool enters
Memory mode. You can view DTCs and Live Data stored in the Scan
Tool’s memory.
1. With the Scan Tool NOT connected to a vehicle, press and release
POWER/LINK
.
If the Scan Tool’s batteries are low, a warning message displays.
Replace the batteries before continuing.
2. If more than one vehicle is stored in the Scan Tool’s memory, the
Vehicle Selection menu displays. Highlight the desired vehicle, then
press ENTER
.
If there are no vehicles
currently stored in the Scan
Tool, an advisory message
displays. Press the M button to
return to the Main Menu.
The Memory System Menu displays.
3. Highlight the DTCs you wish to view,
then press ENTER
.
The Scan Tool displays the
"priority" DTC.
If there are no DTCs currently
stored in the Scan Tool’s
memory, an advisory message
shows on the display.
Press DTC/FF
to scroll through all
stored DTCs. Press DTC/FF to view
Freeze Frame data for the priority
DTC.
When all DTCs have been displayed
and DTC/FF
is pressed, the Scan
Tool displays the first enhanced DTC
stored in memory. Press DTC/FF
to
scroll through all stored enhanced
DTCs.
4. When you have finished viewing data in the Scan Tool's memory,
press and release POWER/LINK
to turn the Scan Tool off.
To Next Page
Loading...