Congratulations on buying the Croozer Baby Supporter.
This purpose-built accessory helps your small child sit up
straight and offers additional comfort when he/she is asleep.
The Croozer Baby Supporter can also be used in Chariot
child transporters. On the two-seater Croozer model
this does lead to considerable reduction in seat width.
1. Fitting the Baby Supporter
Note: The terms “left-hand” and “right-hand” are used as seen
in direction of travel.
1.1 Fitting to Chariot Child Carriers
Undo the buckles of the padded shoulder harness to
remove it.
Locate the Baby Supporter in the carrier so that the triangular
cushion is on the surface of the seat.
From the back, thread the right-hand half of the hip strap
through the elastic loop on the right-hand side of the baby
support. Repeat this procedure on the left-hand side.
Thread the buckle of the crotch belt through the rubber band
on the end of the triangular cushion.
Push the head support up a bit by undoing the Velcro fastener
at the back of the Baby Supporter.
Thread both buckles of the padded shoulder harness back-
wards through the gap between the lower cushion and the
head support.
Owner’s Manual
Croozer Baby Supporter
6
To Next Page
Need help?
General
