What to do if Zyno Medical Water Pump shows Occlusion?
If your Zyno Medical Water Pump displays an occlusion alarm, resolve the cause of the occlusion. The infusion will resume once the pressure is reduced below the alarm threshold.
How to clear air-in-line in Zyno Medical Z-800?
To address the 'Air-in-line' alarm on your Zyno Medical Water Pump: First, acknowledge the alarm by pressing the RUN/STOP key, which will pause the infusion. Next, clear the air from the line, and then press the RUN/STOP key again to resume the infusion.
General| Accuracy | ±5% |
|---|---|
| Type | Infusion Pump |
| VTBI Range | 0.1 to 9999 mL |
| Occlusion Pressure Settings | Low, Medium, High |
| Infusion Modes | Continuous, Intermittent, PCA |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Delivery Rate Range | 0.1 - 1200 ml/hr (depending on syringe size and mode) |
| Flow Rate | 0.1 - 1200 ml/hr (depending on syringe size and mode) |
To Next Page