How to fix 'Air-in-line' error on Zyno Medical Equipment?
To address an 'Air-in-line' alarm on your Zyno Medical Equipment, first, press the RUN/STOP key to acknowledge the alarm. This will pause the infusion. Next, clear any air from the line. Finally, press the RUN/STOP key again to resume the infusion.
General| Brand | Zyno Medical |
|---|---|
| Model | Z-800F |
| Category | Medical Equipment |
| Language | English |
Explains the intended use and purpose of the Z-800F Infusion Pump.
Specifies the required training and qualifications for pump operators.
Details key functionalities and capabilities of the Z-800F Infusion Pump.
Defines and explains the various symbols used on the Z-800F Infusion Pump.
Lists critical safety warnings and precautions for operating the Z-800F pump.
Provides a detailed overview of the pump's physical components and controls.
Outlines the steps for unpacking and setting up the Z-800F Infusion Pump.
Guides the user through powering on the system and starting a new infusion.
Detailed instructions for loading the primary IV administration set into the pump.
Explains programming for continuous infusions using Rate/VTBI or Time/VTBI.
Steps for loading and connecting a secondary administration set.
How to program infusions using time and VTBI parameters.
Describes the process when an infusion finishes and the pump enters KVO mode.
Steps to select and program the TPN auto ramp infusion mode.
How to select and program 10-Step infusion modes (Rate/Volume or Time/Volume).
Steps to select and program the intermittent mode infusion.
Steps to select and program the blood infusion mode.
How to use the PRIME key to remove air bubbles from the IV set.
Instructions for locking and unlocking the pump's keypad.
Procedure for resetting the Volume Infused (VINF) parameter.
Steps to safely turn off the Z-800F Infusion Pump.
Steps for replacing the primary solution container during an infusion.
Procedure for changing the IV set while an infusion is in progress.
How to save and retrieve infusion parameters as protocols.
Steps to save current infusion settings as a new protocol.
Defines terms like Error, Alarm, and Warning as used in the manual.
Lists the different alarms, their meanings, and the corresponding responses.
Details various warning conditions and their associated user actions.
Describes system errors, their meaning, and the required actions.
Technical specifications of the Z-800F Infusion Pump.
Guidelines for storing and transporting the infusion pump safely.
Information on battery type, charging, care, and maintenance.
Procedures and guidelines for cleaning the Z-800F Infusion Pump.
Details regular and periodic inspections required for pump maintenance.
Information on obtaining service and technical support for the pump.
Outlines the warranty terms and conditions for the Z-800F Infusion Pump.
Step-by-step guide for testing various alarms on the Z-800F pump.
Lists administration sets approved for use with the Z-800F Infusion Pump.
Catalog of available accessories for the Z-800F Infusion Pump.
To Next Page