Chapter 8 Wireless LAN
AMG1302-T10A User’s Guide
100
8.2.1 No Security
In the Network > Wireless LAN > AP screen, select No Security from the Security Mode list to
allow wireless devices to communicate with the Device without any data encryption or
authentication.
Note: If you do not enable any wireless security on your Device, your network is
accessible to any wireless networking device that is within range.
Figure 47 Network > Wireless LAN > AP: No Security
The following table describes the labels in this screen.
8.2.2 WEP Encryption
Use this screen to configure and enable WEP encryption. Click Network > Wireless LAN to display
the AP screen. Select Static WEP from the Security Mode list.
Cancel Click this to restore your previously saved settings.
Advanced Setup Click this to display the Wireless Advanced Setup screen and edit more details of your
WLAN setup. See Section 8.2.5 on page 104 for more details.
Table 28 Network > Wireless LAN > AP
LABEL DESCRIPTION
Table 29 Network > Wireless LAN > AP: No Security
LABEL DESCRIPTION
Security Mode Choose No Security from the drop-down list box.
To Next Page
Loading...
