Chapter 10 Firewalls
AMG1302-T10A User’s Guide
146
10.3.1 Configuring Firewall Rules
Use this screen to configure firewall rules. In the Rules screen, select an index number and click
Add or click a rule’s Edit icon to display this screen and refer to the following table for information
on the labels.
Figure 79 Security > Firewall > Rules: Edit
The following table describes the labels in this screen.
Table 53 Security > Firewall > Rules: Edit
LABEL DESCRIPTION
Edit Rule
Active Select this option to enable this firewall rule.
Action for Matched
Packet
Use the drop-down list box to select whether to discard (Drop), deny and send an
ICMP destination-unreachable message to the sender of (Reject) or allow the
passage of (Permit) packets that match this rule.
Source/Destination Address
Address Type Do you want your rule to apply to packets with a particular (single) IP, a range of IP
addresses (for instance, 192.168.1.10 to 192.169.1.50), a subnet or any IP address?
Select an option from the drop-down list box that includes: Single Address, Range
Address, Subnet Address and Any
Address.
To Next Page
Loading...
