AMG1302-T10A User’s Guide 179
CHAPTER 17
Remote Management
17.1 Overview
Remote management allows you to determine which services/protocols can access which Device
interface (if any) from which computers.
The following figure shows remote management of the Device coming in from the WAN.
Figure 100 Remote Management From the WAN
Note: When you configure remote management to allow management from the WAN, you
still need to configure an IP filter rule to allow access.
You may manage your Device from a remote location via:
• Internet (WAN only)
•LAN only
•LAN and WAN
• None (Disable)
To disable remote management of a service, select Disable in the corresponding Service Access
field.
You may only have one remote management session running at a time. The Device automatically
disconnects a remote management session of lower priority when another remote management
session of higher priority starts. The priorities for the different types of remote management
sessions are as follows.
1 Telnet
2 HTTP
To Next Page
Loading...
