Chapter 1 Introduction
AMG1302-T10A User’s Guide
18
1.6 LEDs (Lights)
The following graphic displays the labels of the LEDs.
Figure 3 LEDs
None of the LEDs are on if the Device is receiving power.
Refer to the Quick Start Guide for information on hardware connections.
Table 1 LED Descriptions
LED COLOR STATUS DESCRIPTION
POWER Green On The Device is receiving power and ready for use.
Blinking The Device is self-testing.
Red On The Device detected an error while self-testing, or there is a device
malfunction.
Off The Device is receiving power.
LAN 1-4 Green On The Device has an Ethernet connection with a device on the Local
Area Network (LAN).
Blinking The Device is sending/receiving data to /from the LAN.
Off The Device does have an Ethernet connection with the LAN.
WPS/WLAN Green On The wireless network is activated.
Blinking The Device is communicating with other wireless clients.
Red Blinki
ng The Device is setting up a WPS connection.
Off The wireless network is activa
ted.
DSL Green On The DSL line is up.
Blinking The Device is initializing the DSL line.
Off The DSL line is down.
INTERNET Green On The Device has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a
DHCP server), PPP negotiation was successfully completed (if used)
and the DSL connection is up.
Blinking The Device is sending or receiving IP traffic.
Red On The Device attempted to make an IP connection but failed. Possible
causes are no response from a DHCP server, no PPPoE response,
PPPoE authentication failed.
Off The Device does have an IP connection.
To Next Page
Loading...
