ZyXEL Communications AMG1302-T10A - Configuring the WWW Screen; The Telnet Screen; The WWW Screen

Chapter 17 Remote Management
AMG1302-T10A User’s Guide
181
17.2 The WWW Screen
Use this screen to specify how to connect to the Device from a web browser, such as Internet
Explorer.
17.2.1 Configuring the WWW Screen
Click Advanced > Remote MGMT to display the WWW screen.
Figure 101 Advanced > Remote MGMT > WWW
The following table describes the labels in this screen.
17.3 The Telnet Screen
You can use Telnet to access the Device’s command line interface. Specify which interfaces allow
Telnet access and from which IP address the access can come.
Table 69 Advanced > Remote Management > WWW
LABEL DESCRIPTION
Server Port You may change the server port number for a service, if needed. However, you must use
the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the Device using this
service.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the Device
using this service.
Select All to allow any computer to access the Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the Device using this service.
Apply Click this to save your changes.
Reset Click this to restore your previously saved settings.