ZyXEL Communications AMG1302-T10A - Full Feature NAT + Many-To-Many no Overload Mapping

Chapter 4 Tutorials
AMG1302-T10A User’s Guide
43
This tutorial uses the following example settings:
To do this, you can use either of the following settings:
• Full Feature NAT with many-to-many no overload mapping
• Full Feature NAT with one-to-one mapping
4.5.1 Full Feature NAT + Many-to-Many No Overload Mapping
Use this setting if your applications can use random public IP addresses and the applications are
initiated from the Intranet computers (A and B). For example, VoIP application. See Section 4.5.2
on page 44 if it is not.
To configure this:
1 Click Network > NAT.
2 Select Active Network Address Translation(NAT) and Full Feature in the General screen.
Click Apply.
Table 6 IP Settings in this Tutorial
DEVICE / COMPUTER IP ADDRESS
The Device’s WAN 172.16.1.253 (IP-1)
172.16.1.254 (IP-2)
The Device’s LAN 192.168.1.1
A 192.168.1.2
B 192.168.1.3
C a.b.c.d
A
B
IP-1
C
1
2