ZyXEL Communications Dimension ES-3124 - Sys Sw Commands; Table 28-2 Command Summary: Sys Sw

Dimension ES-3124 Ethernet Switch
28-6 Introduction to CLI
Table 28-1 Command Summary: sys
COMMAND DESCRIPTION
trustedHost <index>[<hostt>]
Sets or displays the SNMP trusted
host.
trapCommunity <index>
[<community>]
Sets or displays the SNMP Trap
community.
trapDest <index>[<destination>]
Sets or displays the SNMP trap
server.
disp <index|all>
Shows SNMP settings.
cluster active <name>
Assign a cluster name and enable
clustering it.
inactive <name>
Disable the cluster named.
add <MAC addr> <password>
Add a member switch into the
cluster using its web configurator
password.
remove <MAC addr>
Remove a member switch from the
cluster.
showMember
Shows details of member switches
in this cluster.
showCandidate
Shows a list of auto-discovered
potential cluster members.
status
Shows whether this switch is a
cluster member, cluster manager
or neither and information about
members in the cluster.
trace
Sets cluster management debug
level.
telnet <MAC>
Telnets to the specified host.
28.2.2 sys sw Commands
The following commands are system switch commands; all are preceded with sys sw.
Table 28-2 Command Summary: sys sw
COMMAND DESCRIPTION
garp status
Shows the GARP timer status.
timer <join timer(ms)><leave
timer(ms)><leave all timer<ms>
Sets the GARP timer’s Join
Timer, Leave Timer and Leave
All Timer.
gvrp trace
Sets GVRP trace level.
enable
Enables GVRP.
disable
Disables GVRP.
status
Shows the GVRP status.