ZyXEL Communications Dimension ES-3124 - Gvrp Status; Gvrp Enable; Gvrp Disable; Vlan1 Q Port Status

Dimension ES-3124 Ethernet Switch
30-4 IEEE 802.1Q Tagged VLAN
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message using GARP.
Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all registrations. GARP
timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800 milliseconds and the Leave
All Timer to 11000 milliseconds.
Figure 30-5 garp timer Command Example
30.4.3 gvrp status
Syntax:
sys sw gvrp status
This command shows the switch’s GVRP settings.
An example is shown next.
Figure 30-6 garp status Command Example
30.4.4 gvrp enable
Syntax:
sys sw gvrp enable
This command turns on GVRP in order to propagate VLAN information beyond the switch.
30.4.5 gvrp disable
Syntax:
sys sw gvrp disable
This command turns off GVRP so that the switch does not propagate VLAN information to other switches.
30.4.6 vlan1q port status
Syntax:
ES-3124> sys sw garp timer 300 800 11000
ES-3124> sys sw gvrp status
GVRP control block status:
gvrpEnable = 1
gvrpPortEnable:
OOOOOOOOOOOOOOOOOOOOOOOOXXXX