Chapter 9 Wireless
AX/DX/EX/PX Series User’s Guide
208
5 If the client device’s configuration interface has an area for entering another device’s PIN, you can
either enter the client’s PIN in the AP, or enter the AP’s PIN in the client – it does not matter which.
6 Start WPS on both devices within two minutes.
7 Use the configuration utility to activate WPS, not the push-button on the device itself.
8 On a computer connected to the WiFi client, try to connect to the Internet. If you can connect, WPS
was successful.
If you cannot connect, check the list of associated WiFi clients in the AP’s configuration utility. If you see
the WiFi client in the list, WPS was successful.
The following figure shows a WPS-enabled WiFi client (installed in a notebook computer) connecting to
the WPS-enabled AP through the PIN method.
Figure 115 Example WPS Process: PIN Method
9.10.8.3 How WPS Works
When two WPS-enabled devices connect, each device must assume a specific role. One device acts
as the registrar (the device that supplies network and security settings) and the other device acts as the
enrollee (the device that receives network and security settings. The registrar creates a secure EAP
To Next Page
Loading...
