Chapter 11 Static Multicast Forwarding
ES-2024 Series User’s Guide
102
Figure 51 Static Mutlicast Forwarding to Multiple Ports
11.2 Configuring Static Multicast Forwarding
Use this screen to configure rules to forward specific multicast frames, such as streaming or
control frames, to specific port(s).
Click Advanced Applications > Static Multicast Forwarding to display the configuration
screen as shown.
Figure 52 Advanced Application > Static Multicast Forwarding
The following table describes the labels in this screen.
Table 21 Advanced Application > Static Multicast Forwarding
LABEL DESCRIPTION
Active Select this check box to activate your rule. You may temporarily deactivate a rule
without deleting it by clearing this check box.
Name Type a descriptive name (up to 32 printable ASCII characters) for this static multicast
MAC address forwarding rule. This is for identification only.
MAC Address Enter a multicast MAC address which identifies the multicast group. The last binary bit
of the first octet pair in a multicast MAC address must be 1. For example, the first
octet pair 00000001 is 01 and 00000011 is 03 in hexadecimal, so 01:00:5e:00:00:0A
and 03:00:5e:00:00:27 are valid multicast MAC addresses.
VID You can forward frames with matching destination MAC address to port(s) within a
VLAN group. Enter the ID that identifies the VLAN group here. If you don’t have a
specific target VLAN, enter 1.
To Next Page
Loading...
