Chapter 13 Spanning Tree Protocol
ES-2024 Series User’s Guide
112
Figure 58 Advanced Application> Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
13.3 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see Section 13.1 on page 107 for more information
on RSTP. Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Table 25 Advanced Application > Spanning Tree Protocol > Configuration
LABEL DESCRIPTION
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree or Multiple Rapid Spanning Tree. See Section 13.1
on page 107 for background information on STP.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
