ZyXEL Communications ES-2024 Series - Link Aggregation Setting; Figure 67 Advanced Application > Link Aggregation > Link Aggregation Setting; Table 36 Advanced Application > Link Aggregation > Link Aggregation Setting

Chapter 17 Link Aggregation
ES-2024 Series User’s Guide
129
17.4 Link Aggregation Setting
Click Advanced Application > Link Aggregation > Link Aggregation Setting to display
the screen shown next. See Section 17.1 on page 127 for more information on link
aggregation.
Figure 67 Advanced Application > Link Aggregation > Link Aggregation Setting
The following table describes the labels in this screen.
Aggregator ID Link Aggregator ID consists of the following: system priority, MAC address, key, port
priority and port number. Refer to Section 17.2.1 on page 128 for more information on
this field.
Status This field displays how these ports were added to the trunk group. It displays:
• Static - if the ports are configured as static members of a trunk group.
• LACP - if the ports are configured to join a trunk group via LACP.
Table 35 Advanced Application > Link Aggregation Status (continued)
LABEL DESCRIPTION
Table 36 Advanced Application > Link Aggregation > Link Aggregation Setting
LABEL DESCRIPTION
Link
Aggregation
Setting
This is the only screen you need to configure to enable static link aggregation.
Group ID The field identifies the link aggregation group, that is, one logical link containing
multiple ports.
Active Select this option to activate a trunk group.