ZyXEL Communications ES-2024 Series - Configuring DHCP Relay; Figure 28 Tutorial: Add Tag for Frames Received on Port 2; Figure 29 Tutorial: Set DHCP Server and Relay Information

Chapter 6 Tutorials
ES-2024 Series User’s Guide
64
Figure 28 Tutorial: Add Tag for Frames Received on Port 2
11 Click the Save link in the upper right corner of the web configurator to save your
configuration permanently.
6.1.3 Configuring DHCP Relay
Follow the steps below to enable DHCP relay on the Switch and allow the Switch to add relay
agent information (such as the VLAN ID) to DHCP requests.
1 Click IP Application > DHCP and then the Global link to open the DHCP Relay
screen.
2 Select the Active check box.
3 Enter the DHCP server’s IP address (192.168.2.3 in this example) in the Remote DHCP
Server 1 field.
4 Select the Option 82 and the Information check boxes.
5 Click Apply to save your changes back to the run-time memory.
Figure 29 Tutorial: Set DHCP Server and Relay Information