Chapter 13 Spanning Tree Protocol
ES-2024 Series User’s Guide
120
and single spanning tree devices. A network may contain multiple MST regions
and other network segments running RSTP.
Figure 57 MSTP and Legacy RSTP Network Example
13.2 Spanning Tree Configuration Screen
Use this screen to select the STP mode for the Switch. To open this screen, click
Advanced Application > Spanning Tree Protocol > Configuration.
Figure 58 Advanced Application> Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 25 Advanced Application > Spanning Tree Protocol > Configuration
LABEL DESCRIPTION
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree or Multiple Rapid Spanning Tree. See
Section 13.1 on page 115 for background information on STP.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
