ZyXEL Communications ES-2024 Series - Page 132

Chapter 14 Bandwidth Control
ES-2024 Series User’s Guide
132
The following table describes the related labels in this screen.
Table 30 Advanced Application > Bandwidth Control
LABEL DESCRIPTION
Active Select this check box to enable bandwidth control on the Switch.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports.
Use this row first to set the common settings and then make adjustments
on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Active Make sure to select this check box to activate ingress rate limit on this port.
Ingress
Rate
Specify the maximum bandwidth allowed in Kilobits per second (Kbps) for
the incoming traffic flow on a port.
If you enter a number between 64 and 1728, the Switch automatically
rounds the number down to the nearest multiple of 64.
If you enter a number between 1729 and 1999, the rate is fixed at 1792.
If you enter a number between 2000 and 103999, the Switch rounds the
number down to the nearest multiple of 1000.
On a Gigabit Ethernet/ Mini-GBIC port, the Switch rounds a number down
to the nearest multiple of 8000 for a number between 104000 and
1000000.
Active Select this check box to activate egress rate limit on this port.
Egress Rate Specify the maximum bandwidth allowed in Kilobits per second (Kbps) for
the out-going traffic flow on a port.
If you enter a number between 64 and 1728, the Switch automatically
rounds the number down to the nearest multiple of 64.
If you enter a number between 1729 and 1999, the rate is fixed at 1792.
If you enter a number between 2000 and 103999, the Switch rounds the
number down to the nearest multiple of 1000.
On a Gigabit Ethernet/ Mini-GBIC port, the Switch rounds a number down
to the nearest multiple of 8000 for a number between 104000 and
1000000.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.