Chapter 20 Queuing Method
ES-2024 Series User’s Guide
155
The following table describes the labels in this screen.
Table 42 Advanced Application > Queuing Method
LABEL DESCRIPTION
Method Select Strictly Priority or Weighted Round Robin Scheduling.
Strict Priority Queuing (SPQ) services queues based on priority only. When the
highest priority queue empties, traffic on the next highest-priority queue
begins. Q3 has the highest priority and Q0 the lowest. The default queuing
method is Strictly Priority.
Weighted Round Robin Scheduling (WRR) services queues on a rotating basis
based on their queue weight (the number you configure in the queue Weight
field). Queues with larger weights get more service than queues with smaller
weights.
When you select Strict Priority, it applies to Q3 only (with priority over all
other queues). Q0 ~ Q2 will use Weighted Round Robin Scheduling.
Weight When you select Weighted Round Robin Scheduling, use the drop-down
list boxes to choose queue weights (1-15). Bandwidth is divided across the
different traffic queues according to their weights.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the Save
link on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
