Chapter 3 Hardware Overview
ES-2024 Series User’s Guide
37
3.2 Rear Panel
The following figures show the rear panel of the Switch. The power receptacle is
on the rear panel.
Figure 14 AC Rear Panel
Figure 15 DC Rear Panel
3.2.1 Power Connector
Make sure you are using the correct power source as shown on the panel.
To connect the power to the Switch, insert the female end of power cord to the
power receptacle on the rear panel. Connect the other end of the supplied power
cord to the power source.
3.3 LEDs
The LEDs are located on the front panel. The following table describes the LEDs on
the front panel.
Table 2 LEDs
LED
COLO
R
STATUS DESCRIPTION
PWR Green On The system is turned on.
Off The system is off.
SYS Green Blinking The system is rebooting and performing self-diagnostic
tests.
On The system is on and functioning properly.
Off The power is off or the system is not ready/
malfunctioning.
ALM Red On There is a hardware failure.
Off The system is functioning normally.
Ethernet Ports
To Next Page
Loading...
