Chapter 8 Basic Setting
ES-2024 Series User’s Guide
72
8.2 System Information
In the navigation panel, click Basic Setting > System Info to display the screen
as shown. You can check the firmware version number and monitor the Switch
temperature, fan speeds and voltage in this screen.
Figure 32 Basic Setting > System Info
The following table describes the labels in this screen.
Table 7 Basic Setting > System Info
LABEL DESCRIPTION
System
Name
This field displays the descriptive name of the Switch for identification
purposes.
ZyNOS F/W
Version
This field displays the version number of the Switch's current firmware
including the date created.
Ethernet
Address
This field refers to the Ethernet MAC (Media Access Control) address of the
Switch.
Hardware Monitor (This section is available for the ES-2024 PWR model only)
Temperature
Unit
The Switch has temperature sensors that are capable of detecting and
reporting if the temperature rises above the threshold. You may choose
the temperature unit (Centigrade or Fahrenheit) in this field.
Temperature MAC, CPU and LOCAL refer to the location of the temperature sensors on
the Switch printed circuit board.
Current This shows the current temperature at this sensor.
MAX This field displays the maximum temperature measured at this sensor.
MIN This field displays the minimum temperature measured at this sensor.
Threshold This field displays the upper temperature limit at this sensor.
To Next Page
Loading...
