Chapter 8 Basic Setting
ES-2024 Series User’s Guide
87
PD Priority This field is only available on the PWR model but not available for the
Gigabit or mini-GBIC ports.
When the total power requested by the PDs exceeds the total PoE power
budget on the Switch, you can set the PD priority to allow the Switch to
provide power to ports with higher priority.
Select Critical to give the highest PD priority on the port.
Select High to set the Switch to assign the remaining power to the port
after all critical priority ports are served.
Select Low to set the Switch to assign the remaining power to the port
after all critical and high priority ports are served.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 13 Basic Setting > PoE Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
