FAN Error
1. CLI:
Figure 3 Enter CLI command “Show hardware-monitor C”.
Note:
If FAN status is error, you can try to replace the FAN model to recovery it, if the
problem cannot resolve, please send to the device to RMA.
Voltage Error
1. CLI:
Figure 4 Enter CLI command “Show hardware-monitor C”.
Note:
If Voltage status is error, the problem may relate power supply or power
source.
Suggestion:
l Using a UPS connect to the switch and monitor a while, if the problem
can resolve, the root cause may relate customer’s environment.
l If problem cannot resolve by connection UPS, the root cause may relate
power supply, please send the switch to RMA.
To Next Page
Loading...
