Chapter 13 Spanning Tree Protocol
ES3500 Series User’s Guide
130
13.4 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see Section 13.1 on page 124 for more information on
RSTP. Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Figure 64 Advanced Application > Spanning Tree Protocol > RSTP
The following table describes the labels in this screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 33 Advanced Application > Spanning Tree Protocol > Configuration (continued)
LABEL DESCRIPTION
Table 34 Advanced Application > Spanning Tree Protocol > RSTP
LABEL DESCRIPTION
Status Click Status to display the RSTP Status screen (see Figure 65 on page 132).
Active Select this check box to activate RSTP. Clear this checkbox to disable RSTP.
Note: You must also activate Rapid Spanning Tree in the Advanced Application >
Spanning Tree Protocol > Configuration screen to enable RSTP on the Switch.
To Next Page
Loading...
