Chapter 5 Initial Setup Example
ES3500 Series User’s Guide
49
5 Click Add to save the settings to the run-time memory. Settings in the run-time memory are lost
when the Switch’s power is turned off.
5.1.2 Setting Port VID
Use PVID to add a tag to incoming untagged frames received on that port so that the frames are
forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any untagged frames
received on that port get sent to VLAN 2.
Figure 26 Initial Setup Network Example: Port VID
1 Click Advanced Applications > VLAN in the navigation panel. Then click the VLAN Port Setting
link.
2 Enter 2 in the PVID field for port 1 and click Apply to save your changes back to the run-time
memory. Settings in the run-time memory are lost when the Switch’s power is turned off.
To Next Page
Loading...
