Chapter 15 Interface Grouping
EX3510-B1 User’s Guide
197
15.2.2 Interface Grouping Criteria
Click the Add button in the Interface Grouping Configuration screen to open the following screen. Use
this screen to automatically add clients to an interface group based on specified criteria. You can
choose to define a group based on a MAC address, a vendor ID (DHCP option 60), an Identity
Association Identifier (DHCP option 61), vendor specific information (DHCP option 125), or a VLAN
group.
Figure 122 Interface Grouping Criteria
Filter Criteria This shows the filtering criteria. The LAN interface on which the matched traffic is received will
belong to this group automatically.
WildCard
Support
This shows if wildcard on DHCP option 60 is enabled.
Modify Click the Edit icon to change the group setting.
Click the Delete icon to delete this group from the Zyxel Device.
Cancel Click Cancel to exit this screen without saving any changes.
OK Click OK to save your changes.
Table 76 Interface Group Configuration (continued)
LABEL DESCRIPTION
To Next Page
Loading...
