ZyXEL Communications EX3510-B1 - 35.3 Rebooting the Device

Chapter 35 Backup/Restore
EX3510-B1 User’s Guide
269
Figure 176 Reset In Process Message
You can also press the RESET button on the rear panel to reset the factory defaults of your Zyxel Device.
Refer to Section 1.5.4 on page 23 for more information on the RESET button.
35.3 Reboot
System Reboot allows you to reboot the Zyxel Device remotely without turning the power off. You may
need to do this if the Zyxel Device hangs, for example.
Click Maintenance > Reboot. Click Reboot to have the Zyxel Device reboot. This does not affect the
Zyxel Device's configuration.
Figure 177 Maintenance > Reboot