Chapter 18 Dynamic ARP
GS1500-24P User’s Guide
135
The following table describes the labels in this screen.
18.6 MAC-IP Binding Config
Click Security > Dynamic ARP > MAC-IP Binding Config in the navigation
panel. The screen will display as shown below.
Figure 66 Security > Dynamic ARP > MAC-IP Binding Config
The following table describes the labels in this screen.
Table 45 Security > Dynamic ARP > Dynamic ARP VLAN Setting
LABEL DESCRIPTION
VLAN (1-4094) Select the range of VLANs you want to perform or bypass validation
checks based on the ARP entries in the ARP table.
State Select Enable to perform validation checks based on the ARP entries in
the ARP table on the selected range of VLANs.
Select Disable to bypass validation checks based on the ARP entries in
the ARP table on the selected range of VLANs.
Note: The default setting for all VLANs is Disabled.
Apply Click Apply to save your changes to the Switch.
Current
enabled VLAN
This field shows the VLANs for which Dynamic ARP validation is enabled.
Table 46 Security > Dynamic ARP > MAC-IP Binding Config
LABEL DESCRIPTION
MAC Address Enter the MAC address in 6 pair hexadecimal format of the network
device you want to be allowed to communicate via the Switch. An
example entry of a MAC address is “0a-b1-c2-d3-e4-f5”.
IP Address Enter the corresponding IP address (in dotted decimal notation, ex
192.168.1.5) of the network device you want to be allowed to
communicate via the Switch.
To Next Page
Loading...
