Chapter 4 The Web Configurator
GS1500-24P User’s Guide
43
SNMP This sub-menu takes you to screens where you can configure the Simple
Network Management Protocol (SNMP) settings.
SNMP
Setting
This link takes you to a screen where you can configure your SNMP
settings.
SNMPv3
Setting
This link takes you to a screen where you can configure your SNMP
v3 settings.
Rate Limit This link takes you to a screen where you can configure rate limits for
traffic flows.
Bandwidth
Control
This link takes you to a screen where you can configure bandwidth limits
on the Switch.
Jumbo Frame This link takes you to a screen where you can configure the Jumbo
Frame size.
Power Over
Ethernet
This link takes you to a screen where you can configure the Power Over
Ethernet settings (PoE).
SECURITY
MAC Address This sub-menu takes you to screens where you can configure MAC
address options.
MAC
Forwarding
Tab le
This link takes you to a screen that displays static and dynamic MAC
forwarding entries.
Static MAC This link takes you to a screen where you can
assign static MAC
addresses for a port.
MAC
Filtering
This link takes you to a screen where you can create filtering rules for
traffic going through the Switch.
802.1x This sub-menu takes you to screens where you can configure IEEE
802.1x port authentication for clients communicating via the Switch.
802.1x
Setting
This link takes you to a screen where you can activate IEEE
802.1x security and configure the RADIUS server settings.
802.1x Port
Setting
This link takes you to a screen where you can configure IEEE
802.1x port authentication settings.
Dynamic ARP This sub-menu takes you to screens where you can activate dynamic
Address Resolution Protocol (ARP) learning and enter static ARP
table entries.
Dynamic
ARP Setting
This link takes you to a screen where you can specify whether
ports are trusted or untrusted ports for ARP inspection.
Dynamic
ARP VLAN
Setting
This link takes you to a screen where you can enable ARP
inspection on each VLAN.
MAC-IP
Binding
This link takes you to a screen where you can manage static MAC-IP
bindings for DHCP snooping and ARP inspection.
Storm Control This link takes you to a screen where you can limit the number of
broadcast, multicast and unknown unicast and multicast packets
the Switch receives per second on the ports.
Defence
Engine
This link takes you to a screen where you can enable the Defence Engine
to prevent the CPU from being flooded with unknown unicast/multicast
packets.
Table 4 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
