ZyXEL Communications GS1500-24P - Port Setting

Chapter 6 System
GS1500-24P User’s Guide
55
The following table describes the labels in this screen.
6.7 Port Setting
Use this screen to configure Switch port settings. Click System > Port Setting in
the navigation panel to display the screen as shown.
The port through which you access the Switch must be in VLAN 1. If you want to
access the Switch through a port that is not in VLAN 1, you must reset the Switch.
Figure 24 System > Port Setting
The following table describes the labels in this screen.
Table 8 System > User Account
LABEL DESCRIPTION
New Username Enter your new username.
New Password Enter your new system password.
Retype Password Retype your new system password for confirmation.
Apply Click Apply to save your changes to the switch.
Table 9 System > Port Setting
LABEL DESCRIPTION
Port Select the port(s) from the list box that you will change the port settings
for. Hold down [Shift] or [CTRL] to highlight more than one port from the
list box.
State Select Enable from the drop-down box to enable a port. The factory
default for all ports is enabled. A port must be enabled for data
transmission to occur. Select Disable to not use a port.