Chapter 7 Link Aggregation
GS1500-24P User’s Guide
63
7.6 LACP Setting
Click Configuration > Link Aggregation > LACP Setting to display the screen
shown next. See Section 7.3.1 on page 60 for more information on dynamic link
aggregation.
Figure 27 Configuration > Link Aggregation > LACP Setting
The following table describes the labels in this screen.
Group ID This field displays all the trunk groups.
Distribution
Algorithm
Parameters
This field displays which Distribution Algorithm Parameters are active for
each trunk group.
SPA represents Source Port.
SMAC represents Source MAC.
DMAC represents Destination MAC.
SIP represents Source IP.
DIP represents Destination IP.
Table 11 Configuration > Link Aggregation > Trunk Distribution Algorithm Setting
LABEL DESCRIPTION
Table 12 Configuration > Link Aggregation > LACP Setting
LABEL DESCRIPTION
Link
Aggregation
Control
Protocol
Note: Do not configure this screen unless you want to enable
dynamic link aggregation.
LACP Status Select Enable from the drop down box to enable Link Aggregation Control
Protocol (LACP). Select Disable to not use LACP.
To Next Page
Loading...
