Chapter 7 Link Aggregation
GS1500-24P User’s Guide
64
7.7 Technical Reference
This section provides technical background information on the topics discussed in
this chapter.
7.7.1 Static Trunking Example
This example shows you how to create a static port trunk group for ports 2-5.
1 Make your physical connections - make sure that the ports that you want to
belong to the trunk group are connected to the same destination. The following
figure shows ports 2-5 on switch A connected to switch B.
Figure 28 Trunking Example - Physical Connections
System
Priority
LACP system priority is a number between 1 and 65,535. The switch with
the lowest system priority (and lowest port number if system priority is the
same) becomes the LACP “server”. The LACP “server” controls the
operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number,
the higher the priority level.
Apply Click Apply to save your changes to the Switch.
Port This field displays the port number.
LACP This field displays if the port has LACP enabled.
Group ID The field identifies the link aggregation group, that is, one logical link
containing multiple ports.
Table 12 Configuration > Link Aggregation > LACP Setting (continued)
LABEL DESCRIPTION
To Next Page
Loading...
