Chapter 9 Spanning Tree Protocol
GS1500-24P User’s Guide
77
9.5 STP Port Setting
Click Configuration > Spanning Tree Protocol > STP Port Setting to access
the screen as shown.
Figure 34 Configuration > Spanning Tree Protocol > STP Port Setting
The following table describes the labels in this screen.
Last Topology
Change Time
This is the time since the spanning tree was last reconfigured.
Apply Click Apply to save your changes to the Switch.
Table 17 Configuration > Spanning Tree > STP Global Setting (continued)
LABEL DESCRIPTION
Table 18 Configuration > Spanning Tree Protocol > STP Port Setting
LABEL DESCRIPTION
Port Select the port(s) to change spanning tree protocol settings for.
Path Cost Path cost is the cost of transmitting a frame on to a LAN through that
port. It is recommended to assign this value according to the speed of
the bridge. The slower the media, the higher the cost.
Type a number from 0 to 200000000. Entering 0 means the Switch will
automatically assign a value.
Priority Configure the priority for the port here.
Priority decides which port should be disabled when more than one port
forms a loop in a switch. Ports with a higher priority numeric value are
disabled first. The allowed range is between 0 and 240 and the default
value is 128.
To Next Page
Loading...
