Chapter 19 Configuration: Port
GS1900 Series User’s Guide
102
19.2.1 The Port Edit Screen
Use this screen to configure Switch port settings. Click Configuration > Port > Port > Edit to
open this screen.
Figure 94 Configuration > Port > Port > Edit
Port Name Displays a descriptive name that identifies this port. The length of the name can be up to
32 alpha-numerical characters.
Note: Due to space limitations, the port name may be truncated in some web configurator
screens.
State Displays the port status as enabled or disabled.
Link Status Displays the link status as up or down.
Speed Displays the speed of the Ethernet connection on this port. The choices are Auto, 10M,
100M, and 1000M.
Duplex Displays the duplex mode of the Ethernet connection on this port. The choices are auto,
full, or half.
FlowCtrl State Displays the flow control state as enabled or disabled. A concentration of traffic on a port
decreases port bandwidth and overflows buffer memory causing packet discards and frame
losses. Flow Control is used to regulate transmission of signals to match the bandwidth of
the receiving port.
Table 60 Configuration > Port > Port > Port (continued)
LABEL DESCRIPTION
To Next Page
Loading...
