Chapter 25 Configuration: Multicast
GS1900 Series User’s Guide
147
Figure 139 Configuration > Multicast > IGMP > Profile
The following table describes the labels in this screen.
25.2.7 The Add/Edit Profile Screen
Use this screen to configure the IGMP Profile settings. Click Configuration > Multicast > IGMP
> Profile > Add/Edit to open this screen.
Figure 140 Configuration > Multicast > IGMP > Profile > Add/Edit
The following table describes the labels in this screen.
Table 105 Configuration > Multicast > IGMP > Profile
LABEL DESCRIPTION
IGMP Profile
Add Click Add to create a new IGMP Profile entry.
Profile Displays the Profile index number.
Group From Displays the profile start group IP address.
Group To Displays the profile end group IP address.
Match Action Displays the action of the profile as Permit or Deny.
Action
Edit Click Edit to make changes to the entry.
Delete Click Delete to remove the entry.
Table 106 Configuration > Multicast > IGMP > Profile > Add/Edit
LABEL DESCRIPTION
IGMP Profile
Profile Enter the Profile index number.
Group From Enter the profile start group IP address.
To Next Page
Loading...
