ZyXEL Communications GS1900-8 - The STP Port Edit Screen

Chapter 26 Configuration: Spanning Tree
GS1900 Series User’s Guide
152
Figure 144 Configuration > Spanning Tree > STP Port
The following table describes the labels in this screen.
26.2.3 The STP Port Edit Screen
Use this screen to configure the STP Port Edit settings. Click Configuration > Spanning Tree >
STP Port > Edit to open this screen.
Table 110 Configuration > Spanning Tree > STP Port
LABEL DESCRIPTION
STP Port
Edit Select this check box to configure the properties of a port. Click the Edit button change the
properties of the port.
Port Displays the index number of the STP port.
State Display the status of the STP port as enabled or disabled.
External Cost Displays the external path cost.
Edge Port Displays the edge port status as Yes or No.
BPDU Filter Displays the BPDU filter status as Yes or No.
P2P MAC Displays the P2P MAC status as Yes or No.