ZyXEL Communications GS1900-8 - The Trap Destination Add;Modify Screen

Chapter 31 Configuration: Management
GS1900 Series User’s Guide
206
The following table describes the labels in this screen.
31.3.10 The Trap Destination Add/Modify Screen
Use this screen to configure the Trap Destination settings. Click Configuration > Management
> SNMP > Trap Destination > Add/Modify to open this screen.
Figure 202 Configuration > Management > SNMP > Trap Destination > Add/Modify
The following table describes the labels in this screen.
Table 167 Configuration > Management > SNMP > Trap Destination
LABEL DESCRIPTION
SNMP Trap Host
Add Click Add to create a new SNMP Trap Host entry.
Server Displays a string identifying the server address that this entry belongs to.
Version Indicates the SNMP trap supported version. Possible versions are:
• SNMP v1: Set SNMP trap supported version 1.
• SNMP v2c: Set SNMP trap supported version 2c.
• SNMP v3: Set SNMP trap supported version 3.
Community/
User Name
Displays the community / user name that this entry belongs to.
UDP Port Displays the trap use destination for the UDP port.
Action
Delete Click Delete to remove the entry.
Table 168 Configuration > Management > SNMP > Trap Destination > Add/Modify
LABEL DESCRIPTION
SNMP Trap Destination
Server Enter the IP address of the server or a string identifying the server address that this entry
belongs to.
Version Select the SNMP trap supported version. Possible versions are:
•SNMP v1: Set SNMP trap supported version 1.
•SNMP v2c: Set SNMP trap supported version 2c.
•SNMP v3: Set SNMP trap supported version 3.
Community
Name
Displays the community name that this entry belongs to.