Chapter 3 Hardware Overview
GS1900 Series User’s Guide
28
3 The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is
functioning properly.
Figure 19 Installed Transceiver
3.1.2.2 Transceiver Removal
Use the following steps to remove a transceiver.
1 Open the transceiver’s latch (latch styles vary).
Figure 20 Opening the Transceiver’s Latch Example
2 Pull the transceiver out of the slot.
Figure 21 Transceiver Removal Example
3.2 Rear Panel
The following figures show the rear panels of the Switch.
Figure 22 Rear Panel: GS1900-8
To Next Page
Loading...
