Chapter 5 The Web Configurator
GS1900 Series User’s Guide
35
5.3 Navigating the Web Configurator
The following summarizes how to navigate the web configurator from the Getting Start screen.
This guide uses the GS1900-10HP screens as an example. The screens may vary slightly for
different models.
Figure 33 The Web Configurator’s Main Screen
The Web Configurator’s main screen is divided into these parts:
• A - Title Bar
• B - Navigation Panel
• C - Main Window
5.3.1 Title Bar
The title bar provides some useful links that always appear over the screens below, regardless of
how deep into the Web Configurator you navigate.
Figure 34 Title Bar
The icons provide the following functions.
Click Logout in a screen to exit the web configurator. You have to log in with your password again
after you log out. This is recommended after you finish a management session for security reasons.
Table 6 Title Bar: Web Configurator Icons
LABEL DESCRIPTION
Logout Click this to log out of the Web Configurator.
OK Click OK to apply the changes.
Cancel Click Cancel to discard the changes.
Save Click this to apply your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
About Click this to display basic information about the Switch.
Help Click this to open the help page for the current screen.
To Next Page
Loading...
