Chapter 19 Configuration: Port
GS1900 Series User’s Guide
116
Fig ure 114 Configuration > Port > Port
The following table describes the labels in this screen.
19.2.2 The Po rt Edit Sc re e n
Use this screen to configure Switch port settings. Click Config ura tio n > Port > Port > Ed it to open this
screen.
Table 62 Configuration > Port > Port
LABEL DESCRIPTIO N
Port
Port Displays the port index number.
Port Name Displays a descriptive name that identifies this port. The length of the name can be up to 32
alpha-numerical characters.
Note: Due to space limitations, the port name may be truncated in some Web Configurator
screens.
State Displays the port status as enabled or disabled.
Link Status Displays the link status as up or down.
Speed Displays the speed of the Ethernet connection on this port. The choices are Auto, 10M, 100M,
and 1000M.
Duplex Displays the duplex mode of the Ethernet connection on this port. The choices are a uto , full, or
ha lf.
FlowCtrl State Displays the flow control state as enabled or disabled. A concentration of traffic on a port
decreases port bandwidth and overflows buffer memory causing packet discards and frame
losses. Flow Control is used to regulate transmission of signals to match the bandwidth of the
receiving port.
Edit Select this check box to configure the properties of a port. Click the Edit button change the
properties of the port.
Cancel Click C a nc e l to discard the changes.
To Next Page
Loading...
